SharkRF openSPOT3 - Ref;Xrf

REF/XRFconnector
YoucanusethisconnectortoconnecttoanetworkwhichsupportstheDplusprotocollikeREForXRF.
TheeasiestwayistousetheQuicksetuptoconnecttothesenetworks.
Ifyouwanttouseareflector,settheURCALLonyourradiotoCQCQCQ,andthelocalmoduletoDinthe
openSPOT3.Ifyouwanttouseagateway,settheURCALLtothegateway'scallsignandremotemodule.
RemotemoduleshouldbethelastcharacteroftheURCALL.Inthiscase,setthelocalmoduletoaspace
characterintheopenSPOT3.
Notethatifyouareconnectingtoarepeater,youhavetosettheReflector/gatewayIDconnectorsettingtothe
callsignoftherepeater.
IftheAutosetURCALLtonetworksettingisenabled,andtheREF/XRFconnector(list)issettoReflectorsmode,
thenthedestinationcallsign(URCALL)ofcallscomingfromyourtransceiverwillbeautomaticallysetto
CQCQCQ.IftheREF/XRFconnector(list)issettoGatewaysmode,thentheURCALLwillbeautomaticallysetto
thegateway'scallsignandremotemodule.
Some(classic)REFandXRFserversneedavalidD-STAR®registration.Youcancheckyourcallsign'sregistration
byclickingontheCheckD-STAR®registrationbutton.Makesureyouhaveregisteredyourlocalmoduleonthe
D-STAR®gatewayregistrationsystem.Ifyouhavearegistration,youhaveprobablyregisteredthe"space"local
module,inthiscasesetyouropenSPOT3'slocalmoduletoaspace(empty)character.
TryremotemoduleEonanyreflectorfortheREF/XRFechoservice(maynotenabledonsomeservers).
Switchingreflectors/gatewaysusingyourradio
URCALL/yourcallmethod
Youcanswitchreflectorsusingyourradiobystartingashortcalltotheirnamesasthedestinationcallsign
(URCALL),like REF001A,or XRF001A.SetthedesiredremotemoduleasthelastcharacteroftheURCALL.You
canswitchtogatewaysthesameway.
TheURCALL/yourcallmethodletsyouchangetothefollowingservertypes:
REF/XRF
86