SharkRF openSPOT3 - P25 Reflector

P25Reflectorconnector
YoucanusethisconnectortoconnecttoanetworkwhichsupportstheP25Reflectorprotocol,likeP25Reflector
servers.
TheeasiestwayistousetheQuicksetuptoconnecttothesenetworks.
Talkgrouphandling
P25Reflectorservershandleonlyonetalkgroup.Youcanfindeachserver'stalkgroupIDintheserverlist,orif
youenableAdvancedmode,thenthetalkgroupIDsettingwillbeshown.
IftheEnablegroupcallreroutingsettingisenabled(it'senabledbydefault),thenallcallsfromyourP25radio
willbeforwardedtothecorrecttalkgroupID,andallcallsfromthenetworkwillbeforwardedtotalkgroupsetat
ReroutegroupcallsfromnettoIDtoyourradio.Inthiscase,makesureyouhavethistalkgroupinyourradio's
selectivecalllist(ifSelCallisenabled),orsetthistalkgroupastheTXcontactfortheradio'scurrentchannel,
otherwiseyouwon'thearincomingcallsonyourradio.
Reroutingcanbeusefulifyoucan'tmodifyyourradio'sconfiguration(youdon'thaveaprogrammingcableor
softwarefortheradio).Inthiscase,keepreroutingenabled,andsettheReroutegroupcallsfromnettoIDto
thetalkgroupyoualreadyhaveinyourradio.
IftheEnablegroupcallreroutingsettingisdisabled,thenyouhavetosendyourcallstothecorrecttalkgroup
(theP25Reflector'sTGID),andincomingcallswillbesenttotheiroriginaldestinationID(theP25Reflector'sTG
ID).
IfyouuseC4FMmodemmode,thenyourcallswillbeautomaticallysenttotheP25Reflector'sTGIDregardless
oftheEnablegroupcallreroutingsetting.
SwitchingP25Reflectorserversusingyourradio
YoucanswitchP25Reflectorserverswithyourradiobycallingthedesiredserver'sIDwithaprivatecall.
Crossmodeusage
TheP25ReflectorconnectorisanP25connector,butitsupportsC4FMcrossmodemmode.Makesureyouuse
VW(VoiceWide)modeonyourC4FMradio,otherwiseyourcallssenttotheserverwillbesilent.
P25Reflector
95