SharkRF openSPOT3 - Dapnet

DAPNETconnector
YoucanusethisconnectortoconnecttoanetworkwhichsupportstheDAPNETprotocol.
TheeasiestwayistousetheQuicksetuptoconnecttotheseservers.
ThisconnectorsupportsthePOCSAGmodemprotocolwhichistheprotocolusedbypagers.Youcanfindmore
informationaboutPOCSAGandDAPNEThere.
TheopenSPOT3actsasatransmitteronDAPNET,somakesureyouuseyourDAPNETtransmitterloginandauth
keyforconnectingtheopenSPOT3.ThesearenotthesameasyourDAPNETuseraccount.Aseparatetransmitter
registrationisneeded.Seethispageformoreinformation.
ThisconnectorcanstayactiveinthebackgroundifStayconnectedinbackgroundischecked,whichmeansyou
canusetheopenSPOT3thesamewayasbeforewithotheractiveconnector,butitwillfunctionalsoasa
personalDAPNET/POCSAGtransmitter.TheopenSPOT3willautomaticallybroadcastDAPNET/POCSAGmessages
whenthere'snocallcomingfromthenetworkormodemforPOCSAGTXdelayseconds(thiscanbesetonthe
Settingspage,POCSAGsettingssection),soongoingcallswon'tbeinterruptedbyPOCSAGmessaging.Ifthe
DAPNETconnectorisrunninginthebackgroundthenyoucanseeit'sconnectionstatusontheStatuspage.
DAPNET
97