SharkRF openSPOT3 - POCSAG Settings

ThemodemwillonlyprocessP25callswithamatchingNetworkAccessCode(NAC).NotethattheopenSPOT3
requirestheNACindecimalformat(example:ifyouhavetheNAC0x293inyourradiothenyouhavetoenter
659intheopenSPOT3).
IfthesourcecallsignofacrossmodecallhasnoassociatedDMR/P25/CCS7ID,anditcan'tbeparsedintoa
number,thentheDefaultcrossmodesourceP25IDwillbeusedfortheoutgoingP25call.Ifyouaretheonly
personusingtheopenSPOT3,setthistoyourDMR/P25/CCS7ID,andthenyoudon'tneedtochangethe
callsignofyourradiotoyourDMR/P25/CCS7ID.
IfAdvancedmodeisenabled,thefollowingsettingsshowup:
IfacallisreceivedbythemodemtotheEchoID,thentheopenSPOT3'sbuilt-inlocalechoservicegets
activated.Itwillrecordthecallandplaysitbackafterthecallisfinished.Bothprivateandgroupcallsare
answeredwithaprivateechocallreply.
IftheAllowonlyIDsascrossmodecallsignssettingisenabled,andthesourcecallsignofacrossmodecallhas
noassociatedIDinthedatabase,andalsoitcan'tbeparsedintoaDMR/P25/CCS7ID,thenthecallwillbe
ignored.
POCSAGsettings
ThissectionisonlyavailableifAdvancedmodeisenabled.
IfthemodemistransmittingPOCSAGmessagesthenitwillswitchtothePOCSAGfrequency.TheTXdelayin
othermodemmodessettingspecifieshowmanysecondstheopenSPOT3shouldwaitafterthelastcallhasbeen
finishedtoswitchtoPOCSAGmodeandstarttransmittingthequeuedmessages.
Settingspage
57