SharkRF openSPOT3 - C4 Fm;Fusion Settings

TheDefaultcallsignforcrossmodecallswillbeusedwhenareceivedDMRorNXDNcalldoesnothaveatalker
alias,orthecall'sIDdoesn'thaveanassociatedcallsigninthedatabase(orthedatabaseisnotavailable).
IfAdvancedmodeisenabled,thefollowingsettingsshowup:
IfacallisreceivedbythemodemtotheEchocallsign,thentheopenSPOT3'sbuilt-inlocalechoservicegets
activated.Itwillrecordthecallandplaysitbackafterthecallisfinished.
IftheForcemessagetoD-STARnetworkincrossmodeisnotempty,thenthespecifiedmessagewillbesentto
theD-STAR®networkifaDMR,C4FMorNXDNcallisreceivedfromthemodem.
IftheTransmitRXconfirmationcheckboxischecked,theopenSPOT3willtransmitashortcallconfirmationafter
thePTTisreleasedontheD-STAR®radio.
IftheAutomuteDTMFcommandscheckboxischeckedandacallisongoingfromthemodem,andaDTMF
sequenceisbeingentered,thenthecalltothenetworkwillbeautomaticallyended,sootherswon'tbeannoyed
byhearingyourDTMFtonesonthesamereflector/gateway.
C4FM/Fusion®settings
TheDefaultcallsignforcrossmodecallswillbeusedwhenareceivedDMRorNXDNcalldoesnothaveatalker
alias,orthecall'sIDdoesn'thaveanassociatedcallsigninthedatabase(orthedatabaseisnotavailable).
IfAdvancedmodeisenabled,thefollowingsettingsshowup:
Allowdatacallstonetwork:ifenabled,datacallswillbeforwardedfromthemodemtothenetwork.This
isnotrequiredfornormaloperation.
IgnoreWires-X®buttoncommands:Wires-X®buttoncommandsreceivedbythemodemwillbeignoredin
casethissettingsisenabled.
DonotconvertWires-X®servernamestouppercase:allservernamessenttothetransceiverare
convertedtouppercasebydefault,andspacecharactersarereplacedwithdashes.Thisconversioncanbe
turnedoffwiththissetting.Theconversionisdonebecausesomeradios(liketheYaesuFT70)donotshow
lowercasecharactersontheirdisplays,andspacecharacterspreventtheradiofromsavingthecurrentserver
toacategory.
Don'tsendautomaticWires-X®connectmessages:theopenSPOT3automaticallysendsWires-X®connect
messagesincaseitconnectsordisconnectsto/fromaserver.Theseautomaticmessagescanbedisabled
withthissetting.
HideprofilesinWires-X®"all"reply:ifthissettingisenabled,configurationprofileswon'tbelistedonthe
firstpageforaWires-X®"all"serversearch.
AutomuteDTMFcommands:ifacallisongoingfromthemodem,andaDTMFsequenceisbeingentered,
andthefirstcharacterisaSpecialcommand/crossmodeprivatecallorCrossmodegroupcallDTMF
Settingspage
55