SharkRF openSPOT3 - Pocsag;Dapnet

YoucansimplyusetheETSIformatifyouwanttosendmessagesthroughthenetwork.Notethatthenetwork
mustknowaboutthelocationofyourSourceID.IfyouwanttoreceiveDMRSMSmessagesfromthenetwork,
youhavetosettheSourceIDtotheDMRIDyousetattheconnectorsettings,orifyouwanttouseanotherID,
thenyouhavetostartashortcallfromthatDMRIDwithyourradio,sothenetworkwillknowthatyourcustom
DMRIDcanbereachedthroughthisopenSPOT3.
POCSAG/DAPNET
YoucanseethePOCSAGmessagequeuehere.Queuedunsentmessagesaredisplayedwithabluebackground,
sentmessagesaregray.AllmessagesreceveidfromDAPNETorsentfromthisinterfacearefirstplacedinthe
POCSAGmessagequeue.
Notethatthedisplayedcurrenttimeslotnumberandtimeiscalculatedbythebrowserandisnotequaltothe
openSPOT3'sinternaldevicetimeandtimeslotframingwhichismoreprecise.
IftheSendtoradiobuttonissettoModemthenyoucandirectlyaddmessagestothequeuewhichwillbe
transmittedbytheopenSPOT3.
Sidepanels/Toolspage
72