SharkRF openSPOT3 - Nxdnreflector

NXDNReflectorconnector
YoucanusethisconnectortoconnecttoanetworkwhichsupportstheNXDNReflectorprotocol,like
NXDNReflectorservers.
TheeasiestwayistousetheQuicksetuptoconnecttothesenetworks.
Talkgrouphandling
NXDNReflectorservershandleonlyonetalkgroup.Youcanfindeachserver'stalkgroupIDintheserverlist,orif
youenableAdvancedmode,thenthetalkgroupIDsettingwillbeshown.
IfyouuseNXDN®modemmode,thenmakesureyousendyourcallsasagroupcalltothetalkgroupID,
otherwisetheserverwillignoreyourcalls.AlsomakesureyouhavethetalkgroupIDinyourSelCalllist(if
SelCallisenabled),otherwiseyouwon'thearincomingcallsonyourradio.
Ifyouusecrossmodes,thensendyourcallsasagroupcalltothetalkgroupID,otherwisetheserverwill
ignoreyourcalls.
IfyouuseaDMRradio,thenmakesurethetalkgroupIDissetastheTXcontactforthecurrentchannelin
yourradio,orthetalkgroupIDisinanRXgrouplistwhichisassignedtothecurrentchannelofyourradio,
otherwiseyouwon'thearincomingcallsfromtheserver.
YoucanalsosettheDefaultcrossmodedestinationIDtothetalkgroupIDandenableAlwaysusethisID
incrossmode.ThesesettingsareavailableontheSettingspage,NXDN®settingssection.Thiswayyour
crossmodecallswillbealwayssenttothecorrecttalkgroupID.
SwitchingNXDNReflectorserversusingyourradio
YoucanswitchNXDNReflectorserverswithyourradiobycallingthedesiredserver'sIDwithaprivatecall.
Crossmodeusage
TheNXDNReflectorconnectorisanNXDN®connector,butitsupportsDMR,D-STAR®,andC4FMcrossmodes.
UsingaDMRtransceiver
YoucanswitchNXDNReflectorserverswithyourDMRtransceiverbycallingthedesiredserver'sIDwithaprivate
call.
UsingaD-STAR®transceiver
NXDNReflector
93