SharkRF openSPOT3 - Location Settings

TheopenSPOT3hasanown,built-invoiceannouncementsystem.Someannouncementsareplayedlocallyfrom
theopenSPOT3'sbuilt-inflashmemory,butsomeareplayedusingouropensourcevoiceannouncementserver.
Modemmodenotes:
DMR:voiceannouncementsaresenttoTG9,sotohearthem,makesureyouhaveTG9inyourradio'sRX
grouplist.
NXDN®:voiceannouncementsaresenttoTG0.
P25:voiceannouncementsaresenttoTG9.
Ifthebatterychargepercentageis15%orbelow,andtheEnablebatterylowannouncementisturnedon,then
theopenSPOT3transmitsbatterychargestatusvoiceannouncementsevery5minutes.
IfyouenableAdvancedmode,thefollowingsettingswillshowup:
YoucanshortenprofileannouncementsbycheckingtheShortenedprofileannouncementcheckbox.
Ifyoudon'twanttohearthelinkedreflector/talkgroupslist,thenyoucanshortenBrandMeister
announcementsbycheckingtheShortenedBrandMeisterannouncementcheckbox.
Youcandisablebuilt-invoiceannouncementsbycheckingtheUseserveronlycheckbox.Notethatstartup
voiceannouncementsplayedrightaftertheopenSPOT3bootswillstillbeplayedfromtheopenSPOT3'sflash
memory.
Youcansetyourownvoiceannouncementserver'shostandport.
Netstateannouncementint.setstheintervaloftheannouncementiftheopenSPOT3can'tconnecttoa
Wi-Finetwork.
SeetheControlcallssectionformoreinformationaboutProfilequery/changebaseID,ConnectorqueryIDandIP
addressqueryID.
Locationsettings
Settinglocationdataisoptional.ItisusedbysomeconnectorsliketheHomebrew/MMDVM®toreportthe
locationoftheopenSPOT3totheconnector'snetwork.
Latitudeandlongitudeisindecimaldegrees.GoogleMapswilldisplayalocation'scoordinatesindecimaldegrees
ifyouclickonit:
Settingspage
53