SharkRF openSPOT3 - Page 11

AUTO(orALLor00,dependingwhat'savailableonyourradio)afteryou'vedonewiththelocalechotest.
RunAutoCalincaseyouusetheC4FMHalfDeviationmodeandtherearevoicequalityissues.Seethe
AutoCal'susagedescriptionintheConnectorssectionbelow.
TakealookattheWires-X®buttonusagedescriptionandtheC4FM/Fusion®APRS®pageifyouwanttoforward
yourtransceiver'sGPSpositiontotheAPRS®network.
NXDN®radiosetup
Setupasimplexchannel(withthesameRXandTXfrequencies).
Setthechannel'sRadioAccessNumber(RAN)totheopenSPOT3'sRAN(bydefaultit's0,itcanbechanged
ontheSettingspage,NXDN®settingssection).
CreateacontactwithprivatecalltoID9999,whichistheopenSPOT3'sbuilt-inlocalechoservice.Makea
calltothisIDtotesttheconnectionbetweenthetransceiverandtheopenSPOT3.
RunAutoCalincaseyouhavevoicequalityissues.SeetheAutoCal'susagedescriptionintheConnectors
sectionbelow.
P25radiosetup
Setupasimplexchannel(withthesameRXandTXfrequencies).
Setthechannel'sNetworkAccessCode(NAC)totheopenSPOT3'sNAC(bydefaultit's0,itcanbechanged
ontheSettingspage,P25settingssection).NotethattheopenSPOT3requirestheNACindecimalformat
(example:ifyouhavetheNAC0x293inyourradiothenyouhavetoenter659intheopenSPOT3).
CreateacontactwithprivatecalltoID9999,whichistheopenSPOT3'sbuilt-inlocalechoservice.Makea
calltothisIDtotesttheconnectionbetweenthetransceiverandtheopenSPOT3.
RunAutoCalincaseyouhavevoicequalityissues.SeetheAutoCal'susagedescriptionintheConnectors
sectionbelow.
POCSAGpagersetup
Makesureyousettheyourpager'sreceivefrequencytotheopenSPOT3'sPOCSAGfrequency,andthatthe
baudratesmatch.Polarityshouldbenormal.TheopenSPOT3'sPOCSAGfrequencyandothersettingscanbe
changedontheSettingspage,POCSAGsettingssection.
MakesureyousettheRIC(s)inyourpager'sconfigurationtotheaddress(es)youwanttoreceivemessages
on.
SeetheDAPNETWikiformoreinformationaboutPOCSAGandDAPNET.
Settingupyourtransceiver
11