SharkRF openSPOT3 - Page 27

EnablingtheGPSreceiver
GotoDISP>APRS®>GPSPOWERandselectON.
EnablingGPSdatasendingduringvoicecalls
GotoDISP>TX/RX>DIGITAL>LOCATIONSERVICEandselectON.
NowyourradiowilltransmitlocationinformationduringyourcallsifithasaGPSfixandyouholdthePTTforat
least2-3seconds.TheopenSPOT3willautomaticallysetanSSIDandsymbolforlocationreportsbasedonthe
transceivertypeinthereceivedlocationdata.
Advancedsettings
IfyouwanttoselectyourownAPRS®symbol,SSIDandcommentforyourtransceiverthenenableAdvanced
mode,gototheConnectorspage,opentheAPRS®connectorsettings,andenableforcedSSID/symbol/comment.
Settingupyourtransceiver
27