SharkRF openSPOT3 - Page 35

IftheopenSPOT3isturnedon,thentheWi-FiLEDwillblinkwhitewhiletheWi-Fibuttonisheld.Theblink
intervalindicateshowmuchtimeisleftuntiltheWi-Fibuttonpressisconfirmed.Confirmationisindicatedby
twoshortwhitestatusLEDblinksandanaudiblebeep(ifthebeeperisenabled).
InAPmode,theopenSPOT3broadcastsit'sownWi-FinetworkcalledopenSPOT3AP.ThestatusLEDis
pulsatingwhiteinaccesspoint(AP)modeandsolidwhiteifaWi-Ficlientisconnected.Youcanusethis
modetosettheopenSPOT3'sWi-Finetworks.SeetheFirststepssectionformoreinformation.
Innormalmode,theopenSPOT3istryingtoconnecttooneoftheWi-Finetworkswhichhavebeenseton
theNetworkpage,Wirelesssettingssection(orusingtheInitializationsetupinAPmode).
Ifthere'snoWi-FinetworksetontheNetworkpage(Wirelesssettingssection)thentheopenSPOT3
automaticallyswitchestoAPmode.
HoldtheWi-Fibuttonfor30secondstoperformafullfactoryreset.Inthiscaseallconfigurationprofileswillbe
cleared.
PresstheWi-Fibutton3timesquicklytoenable/disablepowersaving.
Buttonusage
35