119
Commission groups (Dynamic UPC file)
You can assign PLUs/UPCs to commission groups (1 to 9).
For each PLU/UPC
For a range of PLUs
For a range of PLUs: PLU codes must have already been defined. If not, an error message "NO
RECORD" will appear on the display.
Programming the commission group 1 for PLU 1
For each PLU/UPC
Programming all of PLU 11 thru 20 for the commission group 1
For a range
of PLUs
2235
.@
11
@
20
@
1
t
Ç
PrintKey operation
2065Direct22352215
PGM 2
2215
2065
.
@
@t
Ç
PLU code
(max. 5 digits)
Commission group
(0 - 9, 0: non commision)
To program any PLU/UPC
To program zero
To program for the following PLU/UPC
Ä
UPC code
(6 to 13 digits)
2235
.
@
@@
t
Ç
End PLU code
(max. 5 digits)
Commission group
(0 - 9, 0:non commision)
To apply the current setting of
start PLU code to PLUs within the range
Start PLU code
(max. 5 digits)
To Next Page
Loading...
