Job-Code-Based Programming
This section illustrates how to program items using job codes. Using job codes allows you to program a wide
variety of items in comparison with direct programming.
Start this programming by entering a corresponding job code as shown below.
All the items which can be programmed by the job-code-based programming are listed on this page and the
following, and those which can also be programmed by the direct programming are marked with the symbol
“ ” that follows job codes.
Setting the date
Enter the month (one or two digits), day (two digits), and year (four digits: 2000 – 2099) in this sequence.
Setting the time
Set the time using the military time (24-hour) system. For example, when the time is set to 2:30 AM, enter 230;
and when it is set to 2:30 PM, enter 1430. The time is printed and displayed on the real time system.
To Next Page
Loading...
