Price change function (for PLU/UPCs)
You can use this function when you need to change the unit price or associated department of a PLU/UPC item
in REG/MGR mode.
There are two methods for price changes:
1. Price change mode
You can change the preset price and/or the associated department of a PLU/UPC item without entering PGM
mode.
2. Changing a price during a transaction
When a wrong PLU/UPC price and/or associated department is found during transaction, you can correct
them at the time of the transaction. With the entry of a new price and/or associated department, the preset
price and/or associated department is automatically changed to the new price and/or associated department.
For the Non-PLU type price embedded UPC-A codes, the prices in the codes have the priority over
the preset prices. So, for these codes, a changed price is valid only when the price change is
executed.
Price change mode
Ê
UPC code
Ä
Scan UPC code
"PRICE CHANGE" is displayed.
Ê
Dept no.
Department key
To cancel
To enter 0
åà
c
Unit price
To change the unit price only
To change the associated dept.
using the dept. no. entry key
To change the associated dept.
directly by depressing the
corresponding key
Ê
Changing a price during a transaction
PLU/
UPC
PLU code
PLU/
UPC
Direct PLU
"PRICE & DEPT" is displayed.
"ENTER DEPT#" is displayed.
UPC code
or
Ä
Scan UPC code
å
PLU/
UPC
PLU code Unit price
PLU/
UPC
PLU/
UPC
Direct PLUUnit price
To Next Page
Loading...
