Operating Instructions Chapter 4
CLV65x Bar Code Scanner
Product description
8011980/0000/2009-04-21 © SICK AG · Division Auto Ident · Germany · All rights reserved 41
Further behaviour of the bar code scanner when operated via the buttons:
• Changing into button operating mode is only possible if no other user is logged onto the
bar code scanner for changing the parameters via the SOPAS-ET configuration soft-
ware. If this is the case, however, a descending melody is started by the beeper when
trying to change into the button operating mode. The bar code scanner remains in rea-
ding operation.
• In case a user logs onto the bar code scanner in button operating mode, the bar code
scanner leaves the button operating mode and restarts the reading operation. The bee-
per confirms the change with a descending melody.
• If no function is started in button operating mode or if no button operation can be per-
formed after using a function, the bar code scanner returns into reading operation au-
tomatically after 30 seconds. The beeper confirms the change with a descending
melody.
• The bar code scanner terminates an activated continous function 5 minutes after start.
It returns to reading operation automatically. The beeper confirms the change with a
descending melody.
• If the bar code scanner could not read the bar code in the "TeachIN" (for matchcode)
as well as "Auto-Setup" functions, the "Ready" LED flashes in red for three times. The
beeper reports this with a descending melody. After that the bar code scanner remains
in button operating mode.
• You cannot switch off or turn down the beeper in button operating mode.
To Next Page
Loading...
Need help?
General
