Figure 108: Changing the password
✓
The Ändere Passwort dialog opens.
Figure 109: Dialog for changing the password
2. Enter the previously used password in the Altes Passwort field.
3. Enter a new password in the Neues Passwort field.
Enter at least 1 character or a maximum of 16 characters (all Unicode characters
are allowed).
4. In the Neues Passwort noch einmal eingeben field, enter the new password again.
5. Click Ändere Passwort .
✓
The new password will be applied.
NOTE
The password is transmitted unencrypted on the network for technical reasons. Appro‐
priate measures must be taken to prevent the password from being read.
6.2.1 Overview
This page shows an excerpt of the attributes of the position sensor object (see table 24,
page 29).
•
The Aktuell column shows the currently configured parameters.
•
The Default column shows the factory settings.
•
The ID hex column shows the attribute IDs of the position sensor object.
6.2.2 Units
On this page, the units for direction, speed, acceleration and temperature can be
parameterized from the position sensor object (see table 24, page 29).
•
Code sequence (attribute ID 0Ch)
°
Clockwise
°
Counterclockwise
•
Speed unit (attribute ID 19h)
°
counts/s
°
counts/ms
CONFIGURATION USING THE INTEGRATED WEB SERVER 6
8014213/1EF3/2021-12-08 | SICK O P E R A T I N G I N S T R U C T I O N S | AFS/AFM60 EtherNet/IP
97
Subject to change without notice
To Next Page
Loading...
Need help?
General
