5.4.2 Setting up communication
1. Right-click the Ethernet symbol and select the New Module... command.
Figure 31: Integrating encoder using EDS
✓
The Select Module Type dialog opens.
2. Select the respective encoder type in the Catalog tab.
Figure 32: Select module
Depending on the connected type, the following designation is displayed:
°
AFS60A-Eth/IP for the AFS60 EtherNet/IP
°
AFM60A-Eth/IP for the AFM60 EtherNet/IP
3. Click OK .
✓
The Module Properties [Modulname] dialog opens.
CONFIGURATION USING A PLC
5
8014213/1EF3/2021-12-08 | SICK O P E R A T I N G I N S T R U C T I O N S | AFS/AFM60 EtherNet/IP
53
Subject to change without notice
To Next Page
Loading...
