Maintenance 9410 series
You can only upload firmware to the same type of module; if you have different types of
option modules connected to your meter, you must perform the upload process for
each module type.
You must have:
• Your meter’s option module firmware upgrade (.SI9) file. You can download
upgrade files from www.usa.siemens.com/pds.
• The option module connected to your meter, and have access to your meter’s
internal FTP site.
• FTP access to your meter from the computer running ION Setup.
All option modules do not perform their regular functions during firmware upgrade; they
will not communicate to the meter and the outputs may change state during the
upgrade process.
WARNING
UNINTENDED OPERATION
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
Do not use this device for critical control or protection applications where human or
equipment safety relies on the operation of the control circuit.
1. Obtain the option module firmware (.SI9) files that you want to load onto your
option module(s). Save the files where they can be accessed by the computer
running ION Setup.
2. Start ION Setup.
3. Open the Setup Assistant for your meter.
4. Select the Template screen.
5. Click the Firmware Upgrade tab, then click Upgrade. Enter your meter’s
password (if prompted) and click OK.
6. Navigate to where you have stored the option module firmware. Select the Option
Module firmware file (*.SI9) as the file type.
7. Select the option module firmware (.SI9) file and click Open.
8. Enter your ION Setup password when prompted and click OK.
A dialog box describes the firmware upgrade progress, verifies the firmware, and
finishes with an overview stating whether the firmware was successfully uploaded.
Loading remote display firmware using ION Setup
This procedure is specific to the DIN meters with a remote display, and cannot be
performed on meters with an integrated display.
You can load updates to your meter’s remote display firmware using ION Setup over
an Ethernet connection.
You must have:
• Your meter’s remote display firmware update (.BIN) file. You can download update
files from www.usa.siemens.com/pds.
• The remote display connected to your meter.
• FTP access to your meter from the computer running ION Setup.
7EN05-0336-03 103
To Next Page
Loading...
