9410 series Communications
When configuring communications parameters, ensure you maintain at least one
communication path that allows full access to your device; otherwise you may
permanently lose the ability to change your device’s configuration and access to
additional data.
NOTICE
LOSS OF ACCESS
Failure to follow these instructions can result in loss of access to the device.
Ensure you maintain sufficient access to communicate with and configure your
device.
NOTE: You cannot change the Ethernet port number assignments through your
meter’s display.
1. Press the home button to display your meter’s data screen menu.
2. Navigate to Setup Menu > Ethernet Port Enable Setup.
3. Use the up and down arrows to scroll through the Ethernet ports available on your
meter. Enabled ports have a
beside them.
4. Press the edit button and provide security credentials if required.
5. Use the up and down buttons to highlight the different Ethernet ports.
6. Press the up and down buttons simultaneously to enable or disable the port.
7. Press the select button when you are finished. Press the select button again at the
prompt to accept the changes.
Network protocol control using ION Setup
Use ION Setup to enable, disable or change the port number of the network protocols
supported on your meter.
When configuring communications parameters, ensure you maintain at least one
communication path that allows full access to your device; otherwise you may
64 7EN05-0336-03
To Next Page
Loading...
Need help?
General
