Siemens Aktiengesellschaft
This Manual contains notices which you should observe to ensure your own personal
safety, as well as to protect the product and connected equipment. These notices are
highlighted in the Manual by a warning triangle and are marked as follows according to
the level of danger:
!
DANGER
indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
!
WARNING
indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
!
CAUTION
used with the safety alert symbol indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
CAUTION
used without safety alert symbol indicates a potentially hazardous situation which, if not
avoided, may result in property damage.
NOTICE
used without the safety alert symbol indicates a potential situation which, if not avoided,
may result in an undesireable result or state.
Note the following:
This device and its components may only be used for the applications described in the
catalog or the technical description, and only in connection with devices or components
from other manufacturers which have been approved or recommended by Siemens.
SIMATIC and SIMADYN D are registered trademarks of Siemens AG.
Third parties using for their own purposes any other names in this document which refer
to trademarks might infringe upon the rights of the trademark owners.
Safety guidelines
Correct usage
Trademarks
Copyright SIEMENS AG 2003 All rights reserved
Disclaimer of liability
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including rights
created by patent grant or registration of a utility model or design,
are reserved.
Siemens AG
A&D
Frauenauracher Straße 80
91056 Erlangen
We have checked the contents of this manual for agreement with
the hardware and software described. Since deviations cannot be
precluded entirely, we cannot guarantee full agreement.
However, the data in this manual are reviewed regularly and any
necessary corrections included in subsequent editions.
Suggestions for improvement are welcomed.
Siemens AG 2003
Technical data subject to change.
To Next Page
Loading...
