Siemens D7-SYS - Parameter Access Technique for D7-SYS; General Description of the Parameter Functionalityinformation; Parameters

Communications configuring
3-214 System- and communication configuring D7-SYS - SIMADYN D
Edition 12.2003
3.19 Parameter access technique for D7-SYS
3.19.1 General description of the parameter functionalityinformation
By appropriately parameterizing using operator control devices for
parameters at the block I/O:
• Reading values
• Changing values
• Changing values and saving in the CPU change (cache) memory
• Changing interconnections using BICO technology
• Changing interconnections and saving in the CPU change (cache)
memory
• Reading parameter descriptive elements
You can be used for the Parameter access technique following hardware
platforms:
• T400 technology module
• Application module FM 458
• SIMADYN D standard CPUs
NOTE
Masterdrives operator control devices, for example, OP1S or
“DRIVE ES”/“DRIVE Monitor“ can be used for parameterization.
3.19.1.1 Parameters
When the parameter access technique for D7-SYS you designate block
inputs or outputs as parameter.
There are two types of parameters:
• Monitoring parameters
−
These can be configured at the inputs and outputs of blocks
− Values can only be read.
Hardware
platforms