Communications configuring
System- and communication configuring D7-SYS - SIMADYN D 3-203
Edition 12.2003
There are two possibilities:
• Manually enter the individual tabular parts at the DB in the
"LAD/STL/CSF" application and then transfer this part of the table
• Generate individual source files with different names for each table
sub-set and after being successfully linked-into the DB one after the
other, then transfer
In order to subsequently download tabular values into a DB manually, the
following steps should be carried-out:
• The appropriate DB should be opened by double-clicking in the
"LAD/STL/CSF" application.
• The existing tabular values should be replaced by entering the value
of the subsequent tabular section.
• The DB should be saved.
• The values of the table sub-sets can now be transferred.
The following steps have to be carried-out when subsequently
downloading tabular values into a DB by generating several source files:
• The same DB name should be specified in the header of the individual
source files (*.AWL).
• The individual files may not exceed the memory size of the DB.
• The file names are best numbered in an increasing sequence.
• The individual files are now linked-in as source files as described
above. However, they are still not compiled.
• The first source file is compiled and the tabular values, now available
in the DB, transferred.
• The second source file is compiled so that its tabular values are now
available in the DB. These are now transferred to the S7 control
system.
• Analog to this, the other source files are compiled and transferred one
after the other.
• After the last table sub-set has been transferred, the LASTDB
connection should be set from 0 to 1. This signals that the table has
been transferred.
Manual entry
Generating several
source files
To Next Page
Loading...
