Siemens D7-SYS - Page 326

Communications configuring
System- and communication configuring D7-SYS - SIMADYN D 3-237
Edition 12.2003
Central block @DIS
QTS
YTS
@DIS
-
-
-
-
-
GV
GV
W
W
BO
I
DIS
CTS
ST1
ST2
OP2SYS
CS7.X01
16#0101
16#0040
USS
coupling module
Display
system
Bits for USS stations
0, 8 and 22 are set
-
-
...
Fig. 3-99 Central block @DIS
• Actual value acquisition to display on all three OP2 devices,
selectable using key V1
− The following is output at OP2 together with the configured
connection attributes at actual value input X: Scaling factor=1;
units=0/00 (dependent on the actual value):
PEPSI = x.xxxxxx 0/00
YTS
DISA
--
-
-
-
-
GV
W
W
I
S
I
R
IDIS
ST1
ST2
KEY
NAM
FOR
X
OP2SYS
16#0101
16#0040
1
'PEPSI'
7
OP2 key V1
(actual
value)
Fig. 3-100 DISA
• Setpoint acquisition for display and changing on two OP2
devices (stations 0 and 22), selectable using key V2
−
The following is output at OP2 together with the configured
connection attributes at setpoint output Y: Scaling factor=1;
units=km/h: SPEED = x.xxxxxxx km/h