Siemens FIDAMAT 6 - Page 110

Functions
8.6 Configuration
FIDAMAT 6
108 Operating Instructions, 01/2019, A5E00222135-04
Function
Relay is passive when
Relay conducts cur-
rent
Note
Measuring range 1 to 4 Measuring range 1 to
4 On
Measuring range identifica-
tion
Limit 1 to 4 Limit 1 (to 4) triggered Limit alarm on/off
Control function
(CTRL)
Function control active
(e.g. on change to
operator control
mode;
in the warm-up phase,
when AUTOCAL or
calibration is running)
Function control
deactivated
Signal when:
• Device is decoded
• Warm-up phase
(max. 2 h)
• Calibration running
(AUTOCAL)
• Remote control via inter-
face (ELAN,
PROFIBUS)
Sample gas Supply of sample gas Actuation of valves
Zero gas 1
Supply of zero gas
Actuation of valves
Calibration gas 1 to 4 Supply of calibration
gas
Actuation of valves
Measuring point 1 to 6 Measuring point 1 to
6 selected
For taking a gas sample via
solenoid valves at various
sample points
Signal for measuring
point 1 to 6
Measuring point 1 to
6 selected
For identifying the sample
point (runs in parallel with
measuring point)
Signaling contact When signaling, the
relay is briefly ener-
gized.
e.g. in the case of
AUTOCAL:
Control of a second device
Gas path heating Heating ready for
operation
For identification purposes
Autocal check Autocal difference
too large (func-
tion 24)
Combustion gas Combustion gas
valve is open
Actuation of valves
Combustion air Combustion air valve
is open
Actuation of valves
Operator input prompt Operator intervention
required
Gas connection faulty;
W5 (combustion
air/combustion gas) pre-
sent;
Device in PAUSE /
STANDBY