Siemens FIDAMAT 6 - Overview of operating functions

Appendix
A.4 Overview of operating functions
FIDAMAT 6
178 Operating Instructions, 01/2019, A5E00222135-04
during maintenance work). Handle the modules without touching any chip pins or PCB
traces. In this way, the discharged energy can not affect the sensitive devices.
Discharge your body before you start taking any measurements on a module. Do so by
touching grounded metallic parts. Always use grounded measuring instruments.
A.4 Overview of operating functions
The device functions are listed in the following overview. This list corresponds to software
version V1.3.6.
Table A- 1 Overview of operator control functions
Submenu
Function
Name of function
Analyzer status
1
Analyzer configuration
2
Diagnostic values
3
Logbook
4 Display meas. ranges
Calibration (code 1)
20
Zero calibration
21
Span calibration
22
Setpoints for zero/ span
23
Calibration settings (single/total range calibration)
24
AUTOCAL/-check (only with option board)
25
Drift values
Measuring ranges (code
1)
40
Range selection
41
Define meas. ranges
Parameters (code 1)
50
El. time constants
51
Limits
52
On/off configuration
53
Status messages
54
G. signal display
55
Select digits
56
LCD contrast
57
Ignite flame
58
Date/Time
59
Sample selection
60 Setup logbook
61
Int. valves
62 Adjust external pressure (FIDAMAT 6-G only)
Configuration (code 2)
70
Analog output
71
Relay assignment
72
Binary inputs
73
ELAN configuration
74
Reset