Siemens FIDAMAT 6 - State Change Due to Fault; Maintenance Request

Commissioning
6.3 Commissioning and operation
FIDAMAT 6
62 Operating Instructions, 01/2019, A5E00222135-04
6.3.3 State change due to fault / maintenance request
In the following tables, you will find possible automatic state changes of the device:
Table 6- 1 Change of state due to fault
Fault
Last state
New state
S1: Parameter memory
- - -
S2: Pump does not start up
(FIDAMAT 6-E only)
Warming-up | Standby Standby
S3: Flame does not ignite
Warming-up
Pause
S4: External fault - - -
S5: Oven temperature Warming-up | Standby | Measuring
| Pause
Pause without heating
S7: Flame temperature Warming-up | Standby | Measuring
| Pause
Pause
S8: Combustion air/combustion
gas pressure
Warming-up | Standby | Measuring
| Pause
Pause
S9: Heating is off
Warming-up
Pause without heating
S10: 24 h RAM/Flash check
- - -
S12: Line voltage supply Warming-up | Standby | Measuring
| Pause
Pause
S13: Hardware Warming-up | Standby | Measuring
| Pause
Pause
S14: Measured value > Full-scale
value of characteristic
- - -
S15: Calibration aborted
- - -
Table 6- 2 Change of state due to maintenance request
Maintenance request
Last state
New state
W1: Calibration difference too
great
- - -
W4: Set clock - - -
W5: Combustion air/combustion
gas pressure
Standby | Measuring Warming-up
W6: Temperature sensor display - - -
W7: Electronics/hardware tempera-
ture
- - -
W8: Flame is out
Standby | Measuring
Warming-up
W9: External maintenance request
- - -
W10: AUTOCAL check deviation
- - -
After you have eliminated the cause of a maintenance request or fault, exit the current
operating state using function 91.