Installing
4.3 Cabinet installation
FIDAMAT 6
Operating Instructions, 01/2019, A5E00222135-04
39
4.3 Cabinet installation
If you install the FIDAMAT 6 in a cabinet or a table-top housing, the device's own weight
places too high a load on the chassis. For this reason, it is insufficient to mount only the front
side of the device. In this case, the procedure is as follows:
● Place the device for mounting on support or telescopic rails.
Installation in a hinged frame is also possible.
● Only use supports that accommodate the weight of the device.
● Secure the housing with all four screws.
4.4 Ventilation of the device
Although the FIDAMAT 6 has an built-in fan, you must provide for adequate ventilation.
If several devices are placed in a cabinet, install the FIDAMAT 6 at the top due to its high
heat emission. Alternatively, ensure there is a clearance of at least 4 to 5 cm (1 height unit)
above the device.
Because of the heat emission of the device, a clearance of at least 2 cm from the cabinet
wall and from installed electrical cables is required.
To Next Page
Loading...
