Introduction
1.4 Qualified personnel
FIDAMAT 6
Operating Instructions, 01/2019, A5E00222135-04
11
1.4 Qualified personnel
Persons who install, connect, commission, operate, service, maintain and disassemble the
device must have the following specific qualifications:
● They are authorized and trained or instructed in operating and maintaining devices and
systems according to the safety regulations for electrical circuits, high pressures and
corrosive as well as hazardous media.
● They are trained or instructed in the maintenance and use of appropriate safety
equipment according to the pertinent safety regulations.
1.5 Warranty conditions
We expressly point out that the product quality is exclusively and conclusively described in
the sales contract. The content of this product documentation is neither a part of a previous
or existing agreement, promise or legal relationship, nor is it intended to modify these. All
obligations on the part of Siemens AG are contained in the respective sales contract, which
also contains the complete and solely applicable liability provisions. The provisions defined
in the sales contract for the responsibility for defects are neither extended nor limited by the
remarks in this document.
1.6 Delivery information
The respective scope of delivery is listed on the shipping documents in accordance with the
valid sales contract. These are enclosed with the delivery.
When opening the packaging, please observe the corresponding information on the
packaging material. Check the delivery for completeness and undamaged condition. In
particular, the Order No. on the labels, if present, must be compared with the ordering data.
To Next Page
Loading...
Need help?
General
