Siemens FIDAMAT 6 - Page 69

Operation
7.1 User interface and operating modes
FIDAMAT 6
Operating Instructions, 01/2019, A5E00222135-04
67
Device operating modes
Table 7- 2 Operating modes of the FIDAMAT 6
Mode
Properties
Remarks
Coded display mode
• Measured value display is
shown
• Protected submenus can
only be reached by entering
a code
• The current operating state
of the device (except for
"Measuring") is displayed in
the bottom line
• Function control not active
The device only supplies relia-
ble measured values in this
mode, provided it is in "Measur-
ing" operating state. You reach
this mode from operator control
mode by pressing the [MEAS]
key twice.
Decoded display mode
• Measured value display is
shown
• The submenus protected by
the entered code are acces-
sible
• The current operating state
of the device (except for
"Measuring") is displayed in
the bottom line
• Function control active
• Measured value can be
influenced
You reach this mode from oper-
ator control mode by pressing
the [MEAS] key once and con-
firming or discarding the entries
that were made.
Operator control mode
• Menu or function is dis-
played
• Settings and inputs can be
made
• Function control active
• Measured value can be
influenced
You reach this mode from
"Coded display mode" by enter-
ing the code of the correspond-
ing operation level.
You configure/calibrate the
device in this mode.