LMV Series Technical Instructions
Document No. LV5-10
00
SCC Inc. Page 17 Section 10
AZL5 Software Update: Version 0410 to 0420
The following updates were made with A
ZL5 software version 0420:
1. Display of additional temperature for steam boilers with thermal shock protection.
2. The system is now capable of handling imperial and metric units.
3. The Siemens AZL52 is supplied with English settings.
4. Over Modbus, the non-resettable fuel meters have been replaced by resettable ones.
The following new parameters are now available:
• Temperature acquired by the extra temperature sensor for over-temperature
protection
• Flame signal (LMV51) / flame signal channel A (LMV52)
• Flame signal channel B (LMV52)
AZL5 Software Update: Version 0420 to 0430
The following updates were made with A
ZL5 software version 0430:
1. Introduction of the Cyrillic character set.
AZL5 Software Update: Version 0430 to 0450
The following updates were made with A
ZL5 software version 0450:
1. The load controller’s switching thresholds now display absolute values as well, but the
setting values are still relative values.
2. User MaxLoadMod is now limited by MinLoad and MaxLoad.
3. Correction of Italian translation.
4. Transmission of pressure values via eBus has been corrected.
5. Access level to activate for the flame detector test has been changed to user-level.
6. Introduction of parameter StartPoint Op.
AZL5 Software Update: Version 0450 to 0460
The following update was made with AZL5 s
oftware version 0460:
1. The effect of error message 3163 in communication with ACS450 has been rectified.
To Next Page
Loading...
Need help?
General
