LMV Series Technical Instructions
Document No. LV5-10
00
SCC Inc. Page 19 Section 10
AZL5 Software Update: Version 0480 to 0500
The following updates were made with A
ZL5 software version 0500:
1. Three new languages are available for the AZL52.09 (Cyrillic): Bulgarian, Romanian, and
Turkish.
2. The display when cold start thermal shock protection is active has been enhanced. The
display no longer alternates between “Coldstart is activated” and “Warning”. Now instead of
“Warning”, a display showing the actual values (temperature / pressure) appears.
3. During interface mode, the actual values for pressure or temperature and flue gas
recirculation (FGR) temperature are now displayed.
4. A message appears when speed standardization is started and the safety loop is open.
5. Display of the raw flame signals even for LMV51 controllers.
6. The combustion efficiency is transmitted via Modbus or eBus as the value “0” if a valid value
cannot be calculated.
7. Support of the new functions for the LMV52.4 for fiber mesh burners.
8. The absolute values of the SD_ModOn and SD_ModOff activation / deactivation values for
the load controller with the units °F / PSI are now displayed correctly.
9. The text displayed on the AZL5 when parameters are being uploaded from the LMV5 to the
AZL5 has been changed from “Backup is made” to “Backup is being made” in order to avoid
misunderstandings.
10. The text displayed on the AZL5 when parameters are being downloaded from the AZL5 to
the LMV5 has been changed from “Backup restore is carried out” to “Backup restore is being
carried out” in order to avoid misunderstandings.
11. Display text has been corrected for the O
2
trim control delay time. “Delay Time…” is now
shown instead of “Dela Time…”.
12. Italian display text for backup corrected from eseguio (incorrect) in eseguito.
13. Designation for O2 guard (O2 limiter, O2 monitor) changed to O2 alarm for English.
14. Support of all new and enhanced parameters.
15. On software version 0500 of the AZL5, the restoring of backup data from LMV5 devices
with a larger scope of functions and with more parameters into LMV5 devices with a smaller
scope of functions and fewer parameters is prevented.
Example:
• Backup file from an LMV52 cannot be restored into an LMV51
• Backup file from an LMV51 can be restored into an LMV52
To Next Page
Loading...
Need help?
General
