Siemens SENTRON PAC3200 - Page 148

Parameterize
9.2 Parameterizing the operator interface
SENTRON PAC3200
148 Manual, 02/2008, A5E01168664B-04
RESET
The "RESET" dialog box enables resetting of the device settings to the instantaneous values
or the factory default values. The following groups of values can be reset:
● Maximum/minimum values
● Counters
● Universal counter
● Factory defaults
● Communication parameters
F4
does not immediately reset a value group but marks the group instead. The
"EXECUTE..." menu entry resets the marked value groups.
NOTICE
Restart of the device
Resetting of the last two value groups "FACTORY DEFAULTS" and "COMMUNICATION
PARAMETERS" results in restart of the device.
After calling the "EXECUTE" menu entry with the F4 key , a cautionary question
appears on the display: "Really execute functions?". Answer the question with F1 or F4.
● F1
: Cancel action. The display returns to display mode. All selected value groups
are deselected.
● F4
: Reset selected value groups.
After execution with F4
, the confirmation "SELECTION EXECUTED" appears on the
screen or the device restarts.
Confirm the message "SELECTION EXECUTED" with F4
.
Figure 9-23 "RESET" device setting
CLEAR MIN/MAX-VALUES Resets all minimum and maximum values to
the instantaneous value.
RESET COUNTERS Resets the following counters to 0 (zero):
• Energy counter for active energy,
reactive energy, apparent energy.
• Working hours counter
UNIV.COUNTER RESET Resets the configurable universal counter to
0 (zero).
FACTORY DEFAULTS Resets the device settings to the default
values. Clears minimum/maximum values.
Resets all counters.