Technical specifications
9.8 KP32F - Bit assignment in the process image
KP8, KP8F, KP32F
120 Operating Instructions, 11/2011, A5E03284305-02
Output area of the controller
Each of the three questions has its own output byte. The LEDs are assigned to the bits in the
output area of the controller as follows:
For the DOe output bytes 0 to 2, the DOe bit combinations of the bit x are illustrated in the
following table.
Bit R x (red, byte 0) Bit G x (green, byte 1) Bit B x (blue, byte 2) LED
1 0 0 Red
0 1 0 Green
0 0 1 Blue
1 1 0 Yellow
1 1 1 White
0 0 0 OFF
1 0 1 OFF
0 1 1 OFF
Output area, slot 1
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Description Output
D07 D06 D05 D04 D03 D02 D01 D00 LEDs 0 to 7,
red
Byte 0
D07 D06 D05 D04 D03 D02 D01 D00 LEDs 0 to 7,
green
Byte 1
D07 D06 D05 D04 D03 D02 D01 D00 LEDs 0 to 7,
blue
Byte 2
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Description Output
D15 D14 D13 D12 D11 D10 D09 D08 LEDs 8 to 15,
red
Byte 3
D15 D14 D13 D12 D11 D10 D09 D08 LEDs 8 to 15,
green
Byte 4
D15 D14 D13 D12 D11 D10 D09 D08 LEDs 8 to 15,
blue
Byte 5
D = LED
To Next Page
Loading...
Need help?
General
