Siemens SIMATIC KP8 User Manual

KP8, KP8F, KP32F
Operating Instructions, 11/2011, A5E03284305-02
71
Assigning parameters for the HMI device in STEP 7
6
6.1 Checklist "Assign parameters for the HMI device"
Parameter assignment in STEP 7 and on the HMI device are required for operation of the
HMI device. Information on how to assign parameters of the fail-safe I/O in STEP 7, is
available in the Programming and operation manual "S7 Distributed Safety - Configuring and
Programming" (http://support.automation.siemens.
com/WW/
view/en/22099875) and in the
"Safety Technology in SIMATIC S7" system manual
(http://support.automation.siemens.
com
/WW/view/en/12490443).
● Parameter assignment checklist for KP8 and KP8F
Test step Information Check
Assign parameters for slot 0 Assigning parameters for the KP8 and KP8F
(Page 74)
Assign parameters for slot 1 Setting the properties of the digital inputs/outputs
(Page 76)
Assign parameters for slot 2 of
the KP8F
KP8F – Setting the fail-safe properties (Page 77)
● Parameter assignment checklist for KP32F
Test step Information Check
Setting PROFINET Setting the properties for PROFINET (Page 85)
Setting the addresses of the
inputs/outputs and the properties
of the light test
Setting the properties and addresses of the lights
and buttons (Page 85)
Setting the properties of the
digital inputs
Setting the properties of the digital inputs
(Page 87)
Setting the properties of the
digital inputs/outputs
Setting the properties of the digital inputs/outputs
(Page 88)
Setting the fail-safe properties Setting the fail-safe properties (Page 89)
6.2 Integrating GSDML in STEP 7
If the HMI device is not listed in the hardware catalog of HW Config, you need to integrate a
valid GSD (device database) file for the HMI device in the STEP 7 database.

Siemens SIMATIC KP8 Specifications

General

Brand	Siemens
Model	SIMATIC KP8
Category	Control Panel
Language	English