Safety instructions and approvals
2.3 TÜV certificate
KP8, KP8F, KP32F
Operating Instructions, 11/2011, A5E03284305-02
27
2.3 TÜV certificate
The HMI device is certified according to the following standards. The latest edition of the
standard can be found in the report for the Technical Inspectorate Certificate.
Safety subject Standard
IEC 61508:2010
EN ISO 13849-1:2008
Functional safety
DIN EN 954-1:1997
Basic safety DIN EN 61131-2:2007
EN 60204-1:2006
NFPA 79:2007
EN 62061:2005
IEC 61511:2003
Machine Safety
ISO 13850:2008
You can obtain a copy of certificates and reports from the Technical Inspectorate at the
following address:
Siemens AG
Industry Sector
I IA AS FA SYS
Postfach 1963
92209 Amberg
Germany
You can find the certificates from the Technical Inspectorate in the Internet at the following
address:
"Technical Support (http://www.siemens.de/automation/csi_en_WW
)"
2.4 Notes about Usage
The HMI device is designed for industrial use, limit class A. The following standards are met:
● Requirements for emissions EN 61000-6-4:2007
● Requirements for interference immunity DIN EN 61000-6-2:2005
Note
The HMI device is not suitable for operation in residential areas: Operation of an HMI
device in residential areas can have a negative impact on radio and TV reception.
If the HMI device is used in a residential area, you must take measures to achieve Limit
Class B conforming to EN 55016 for RF interference.
Suitable measures to achieve Limit Class B for suppression of radio interference include:
● Installation of the HMI device in a grounded control cabinet
● Use of filters in electrical supply lines
Individual acceptance is required.
To Next Page
Loading...
