Safety instructions and approvals
2.2 Approvals
KP8, KP8F, KP32F
Operating Instructions, 11/2011, A5E03284305-02
25
2.2 Approvals
Note
The following overview shows possible approvals for the HMI device.
The HMI device itself is certified as shown on the label on its rear panel.
CE mark
The HMI device meets the general and safety-related requirements of the following EU
directives and conforms to the harmonized European standards for programmable logic
controllers published in the official gazettes of the European Union:
● 2004/108/EC "Electromagnetic Compatibility" (EMC Directive)
● 2006/95/EC "Electrical Equipment Designed for Use within Certain Voltage Limits" (Low-
voltage Directive)
EC Declaration of Conformity
The EC Declarations of Conformity are kept available for the responsible authorities at the
following address:
Siemens AG
Industry Sector
I IA AS FA SYS
Postfach 1963
92209 Amberg
Germany
Explosion protection approval
For the HMI device
● EN 60079-0
● EN 60079-15
● EN 60079-31
the following approvals are in place:
II 3 G II 3 G Ex nA IIC T4 Gc
II 3 D II 3 D Ex tc IIIC T 70 °C Dc IP65
The design examination certificate is available at the following Internet address:
Technical Support (http://www.siemens.de/automation/csi_en_WW
)
To Next Page
Loading...
Need help?
General
