12 Station Configuration Editor Tool
159
Commissioning PC Stations - Manual and Quick Start
Release 5/2005
C79000-G8976-C156-07
Configuring Activation of Warnings
When warnings are enabled, a new event in the diagnostic buffer causes a display
in the station manager ICON in the system tray. Whether a warning is indicated
depends on the set warning level.
Here, you can configure the warning activation (yellow ! character) over the Station
Manager icon in the system tray of the taskbar. The following settings are possible:
S Activate warnings on or off
S Select warning activation depending on the weighting of the error:
- When errors and important errors occur
or
- Only when important errors occur.
Default setting: Only when important errors occur.
Accept Partial Loading
If the “accept partial loading” property is activated, the Station Manager also
accepts defined configurations that contain only part of the configuration visible in
the Station Configuration Editor.
The components (modules and applications) that do not receive an engineered
configuration are fully deleted if you download only part of the configuration
(engineered configuration is lost). These are, however, retained in the configuration
of the station manager (with the appropriate status displayed: Component does not
exist or is not configured in the current PC station configuration).
Default setting : Accept partial load.
To Next Page
Loading...
Need help?
General
