10 Example — SNMP Communication with OPC
128
Commissioning PC Stations - Manual and Quick Start
Release 5/2005
C79000-G8976-C156-07
10 Example — SNMP Communication with OPC
Introduction
This section describes how you link network components and nodes with an SNMP
agent to a PC station over an OPC SNMP server. You will learn which tools to use
to configure a PC station to implement the interfacing of a device with SNMP
capability and how make the SNMP variables and SNMP traps available on the
OPC interface.
You will find information about the SNMP OPC server on the Web at:
http://www.siemens.com/snmp-opc-server
Initial Situation
If you want to try out the example yourself, you require the following:
S a PC
S a network adapter
S the SIMATIC NET CD 11/2003 software
S a device with SNMP capability (for example SIMATIC NET OSM/ESM)
S a network connection between the OPC SNMP server and the device with
SNMP capability
For the PC station, you require a STEP 7 project that was created on a central ES
station (not this PC station). This should contain the hardware configuration.
To Next Page
Loading...
