A Notes for Users of Older Versions
284
Commissioning PC Stations - Manual and Quick Start
Release 5/2005
C79000-G8976-C156-07
DP 5613 up to version 2.1 for Windows 2000 Pro or Windows NT 4.0
Situation:
A DP project engineering configuration created with the COM PROFIBUS program
cannot be used.
What to do:
A DP project engineering configuration created with the COM PROFIBUS program
must be recreated with SIMATIC NCM PC V5.1 Service Pack 2 or higher or STEP
7 Version 5.1 Service Pack 2 or higher.
If the project engineering configuration was already created with STEP 7, this
STEP 7 project can continue to be used. You only need to download the project
engineering configuration to the CP/PC station from STEP 7 Version 5.1 Service
Pack 2 or higher.
FMS-5613 up to version 2.1 for Windows 2000 Pro or Windows NT 4.0
Situation:
An FMS project engineering configuration created with the COM PROFIBUS
program cannot be used.
What to do:
An FMS project engineering configuration created with the COM PROFIBUS
program must be recreated with SIMATIC NCM PC V5.1 Service Pack 2 or higher
or STEP 7 Version 5.1 Service Pack 2 or higher.
S7-5613 up to version 2.1 for Windows 2000 Pro or Windows NT 4.0
Situation:
An S7 project engineering configuration created with the COML S7 program
cannot be used.
What to do:
A project engineering configuration created with the COML S7 program must be
recreated with SIMATIC NCM PC V5.1 Service Pack 2 or higher or STEP 7
Version 5.1 Service Pack 2 or higher.
If the project engineering configuration was already created with STEP 7 (XDB),
this STEP 7 project can continue to be used. You only need to download the
project engineering configuration to the CP/PC station from STEP 7 Version 5.1
Service Pack 2 or higher.
To Next Page
Loading...
Need help?
General
