EasyManuals Logo

Siemens SIMATIC NET Manual&Nbsp;

Siemens SIMATIC NET
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #286 background imageLoading...
Page #286 background image
A Notes for Users of Older Versions
286
Commissioning PC Stations - Manual and Quick Start
Release 5/2005
C79000-G8976-C156-07
SOFTNET-S7 up to version 5.3 for Windows 2000 Pro, Windows NT 4.0 or
Windows 98
Situation:
Windows 98 is no longer supported.
An S7 project engineering configuration created with the COML S7 program
cannot be used.
What to do:
Under Windows 98, use the SIMATIC NET CD 05/2000.
A project engineering configuration created with the COML S7 program must be
recreated with SIMATIC NCM PC V5.1 Service Pack 2 or higher or STEP 7
Version 5.1 Service Pack 2 or higher.
If the project engineering configuration was already created with STEP 7 (XDB),
this STEP 7 project can continue to be used. You only need to download the
project engineering data to the CP/PC station from STEP 7 Version 5.1 Service
Pack 2 or higher.

Table of Contents

Other manuals for Siemens SIMATIC NET

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC NET and is the answer not in the manual?

Siemens SIMATIC NET Specifications

General IconGeneral
CategoryIndustrial Communication Software
ManufacturerSiemens
Operating SystemsWindows, Linux
Protocols SupportedPROFIBUS, PROFINET, OPC UA
CompatibilitySiemens PLCs, Third-party devices with supported protocols

Related product manuals