Siemens SIMATIC PCS 7 Operating Instructions

Clearances, 18
Commissioning
Requirements, 53
Components of an ET 200PA SMART, 15
Configuration
horizontal, 17
Number of active bus modules, 21
Number of modules, 21
vertical, 17
Configuration message frame
Look on the Internet under ..., 5
Configuration with active bus modules, 35
Connecting comb, 43
CSA approval, 213
Current consumption
Rules, 24
D
Delay time
ET 200PA SMART, 120
Device-related diagnostics, 115
DI 16 x DC 24 V
Diagnostic messages, 136
Parameters, 134
Redundant sensor supply, 131
Resistance circuit of the sensors, 132
Technical specifications, 133
Wiring diagram, 131
DI 16 x DC 24 V, with hardware and diagnostic
interrupts
Properties, 130
DI 32 x DC 24 V
Properties, 126
Technical specifications, 128
Wiring diagram, 126
Diagnostic blocks, 87
Diagnostic interrupt, 105, 115
Diagnostic messages
AI 16 x 16 Bit, 185
AO 8 x 12 Bit, 209
DI 16 x DC 24 V, 136
DO 16 x DC 4 V/0.5 A, 147
of the AI 8 x 16 Bit, 175
of the AI 8 x TC/4 x RTD, 200
Diagnostics, 92
Channel-related, 99
Channel-related error messages, 101
Device-related, 115
Expanded, 92
H-status, 103
Interrupts, 105
Module status, 98
Structure, 92
Digital input module
DI 16 x DC 24 V, with hardware and diagnostic
interrupts, 129
DI 32 x DC 24 V, 125
Digital module
Dimension drawing, 211
Digital output module
DO 32 x DC 24 V/0.5 A, 137
Digital output module DO 16 x DC 24 V/0.5 A, 142
Dimension drawing
Analog module, 211
Digital module, 211
IM 650, 119
Signal module, 211
Discharging interference
via integrated RC network, 27
Discharging of interference
via integrated RC network, 27
Distributed I/O device, 13
DO 16 x DC 24 V/0.5 A
Diagnostics, 147
Properties, 142
Technical specifications, 144
Wiring diagram, 143
DO 32 x DC 24 V/0.5 A
Properties, 138
Technical specifications, 140
Wiring diagram, 139
DP address
See PROFIBUS address, 39
DP master, 13
DP slave, 13
Driver blocks, 87
E
Electrical influences
Protection from, 23
Electrical installation
Configuring, 22
Electrically isolated modules, 29
EMERGENCY STOP devices, 22
End of cycle interrupt, 105
End sleeves, 42
Equipment
open, 31
Error messages
Channel-related, 101
ET 200PA SMART
Accessories, 15
Index
ET 200PA SMART
222 Operating Instructions, 06/2019, A5E34192013-AB

Siemens SIMATIC PCS 7 Specifications

General

Brand	Siemens
Model	SIMATIC PCS 7
Category	Control Systems
Language	English