Siemens SIMATIC S5 - Page 167

Programming Instructions
R 02/92
9.5.2 Jumper Assignment of the Digital Position Decoder
Jumper assignment on the basic module
DIP switch S1
B
==
;
3
4
5
6
7
8
9
~ Interrupt A:
S1.2 inserted with: W=3~:~
S5–155U
(S5-155U mode)
~ Module address (basic address 128):
H
10
(P-area) “
11 S1.9 inserted
12
13
14
15
16
~ PESP signal active: S16 inserted
17
18
19)
~ S1.18 and S1 .19, see section 2.2
As the transducer voltage is 5 V, the following resistor values must be soldered in on the basic
module:
R27
R18
R30
Interrupt processing:
39 kQ
82 Q
open
For the interrupt processing (see section 2.4), the digital position decoder 1P 241 is coded as a
master module.
DIP switch
1 2345678
9 10
II
II
Setting for rogrammable controller
8S5–150 S/ and S5–155U
In this example, all jumpers of switch S2 must be opened for all other programmable controllers.
9 – 46
1P 241 Equipment Manual
@ W3Mf3flS AG 1989, Order No.: 6ES5 998-0KD21
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com