Electrical installation
4.10 Other connections
Converter cabinet units
124 Operating Instructions, 07/2016, A5E03347396A
Figure 4-22 Circuit proposal for control via the Control Unit
Circuit proposal with customer terminal module TM31 (option G60)
The following circuit proposal can be used to control the auxiliary contactor for example. The
"Pulses enabled" signal at terminal-X542 of the TM31 is then no longer available for other
purposes.
Figure 4-23 Circuit proposal for control via the TM31
Note
Additional protective conductor
If 230 V AC is applied to the relay outputs, the TM31 must also be grounded via a 6 mm²
protective conductor.
To Next Page
Loading...
