Siemens SINAMICS G150 - Web Server Configuration

Functions, monitoring, and protective functions
9.2 Drive functions
Converter cabinet units
546 Operating Instructions, 07/2016, A5E03347396A
9.2.23.3
Web server configuration
Configuration via STARTER
The configuration dialog box is opened by selecting the drive in the project navigator and
clicking "Web server" in the shortcut menu.
Figure 9-12 Configuring web server via STARTER
Activating the web server
The web server is already active in the factory settings.
Access can be restricted to a secure connection (https) if necessary.
Note
Access via a secure connection (https)
You require security certificates for both SINAMICS and the Internet browser to access the
web server via an https connection. These security certificates must be installed on e
very
computer, from which the web server is to be called.
Contact your system administrator about this.
Enabling users
The user "SINAMICS" is enabled in the factory settings. A password can be defined for this if
necessary.
The user "Administrator" is not enabled in the factory settings. If it is enabled, a password
can also be defined.