Siemens SINAMICS G150 - Chapter Content

Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
469
Output terminals
8
8.1
Chapter content
This chapter provides information on:
● Analog outputs
● Digital outputs
The analog/digital outputs described are located on the TM31 customer terminal block,
which is available only with option G60.
As an alternative to the analog/digital outputs of the TM31, it is possible to use the terminals
on the Control Unit or on the Terminal Board TB30 (option G62).
Some of the outputs on the Control Unit and on the TM31 are pre-assigned at the factory;
the outputs on the TB30 are not pre-assigned at the factory.
Function diagrams
At certain points in this chapter, reference is made to function diagrams. These can be found
on the customer DVD in the "SINAMICS G130/G150 List Manual", which provides
experienced users with detailed descriptions of all the functions.