Commissioning
5.2 STARTER commissioning tool
Converter cabinet units
198 Operating Instructions, 07/2016, A5E03347396A
Installing the STARTER commissioning tool
STARTER is installed using the "setup" file on the customer DVD supplied. When you
double-click the "Setup" file, the installation Wizard guides you through the process of
installing STARTER.
Note
Installation time
The insta
llation time depends on the computer performance and from where the software is
installed (e.g. DVD, hard disk, network). We recommend that you install the software from a
local data carrier.
Layout of the STARTER user interface
STARTER features four operating areas:
Figure 5-1 STARTER operating areas
To Next Page
Loading...
