Siemens SINAMICS G150 - Command Sources

Operation
6.4 Command sources
Converter cabinet units
276 Operating Instructions, 07/2016, A5E03347396A
6.4
Command sources
6.4.1
"PROFIdrive" default setting
Preconditions
The "PROFIdrive" default setting was chosen during commissioning:
•
STARTER (p0700):
"PROFIdrive"
•
AOP30 (p0700):
"5: PROFIdrive"
Command sources
Figure 6-9 Command sources – AOP30 <--> PROFIdrive
Priority
The command source priorities are shown in the diagram "Command sources - AOP30 <->
PROFIdrive".
Note
Emergency OFF signals
The emergency OFF and motor protection signals are always active (regardless of the
command source).
All of the supplementary setpoints are deactivated for LOCAL master control.