Siemens SINAMICS G150 - Page 277

Operation
6.4 Command sources
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
277
TM31 terminal assignment with "PROFIdrive" default setting (if option G60 is present)
When you choose the "PROFIdrive" default setting, use the following terminal assignment for
TM31:
Figure 6-10 TM31 terminal assignment with "PROFIdrive" default setting
Control word 1
The bit assignment for control word 1 is described in "Description of the control words and
setpoints".
Status word 1
The bit assignment for status word 1 is described in "Description of the status words and
actual values".
Changing over the command source
The command source can be changed over using the LOCAL/REMOTE key on the AOP30.