Functions, monitoring, and protective functions
9.4 Monitoring and protective functions
Converter cabinet units
580 Operating Instructions, 07/2016, A5E03347396A
Temperature measurement via PT1000
The connection is made to user terminal block (TM31) at terminal X522:7/8. The measured
temperature is limited to between –99 °C up to +188.6 °C and is available for further
evaluation.
● Activating the motor temperature measurement via the external sensor: p0600 = 10
If the customer terminal block TM31 (option G60) is available and after commissioning
has been completed, the source for the external sensor is set to the customer terminal
block (p0603 = {TM31} r4105).
● Set the PT1000 temperature sensor type: p4100 = 6.
Temperature sensor connection at a Sensor Module (option K50)
Temperature measurement via KTY
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module in the forward direction of the diode (see corresponding section in chapter "Electrical
installation").
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the KTY temperature sensor type: p0601 = 2.
Temperature measurement via PTC
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module (see corresponding section in chapter "Electrical installation"). The threshold for
changing over to an alarm or fault is 1650 Ω.
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the PTC temperature sensor type: p0601 = 1.
Temperature measurement via PT1000
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module (see corresponding section in chapter "Electrical installation").
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the PTC temperature sensor type: p0601 = 6.
To Next Page
Loading...
