Siemens SINAMICS G150 - AOP Settings

Operation
6.6 Control via the operator panel
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
297
Figure 6-24 Curve recorder - manual scaling
After setting and applying the limits, you switch to the curve recorder and manual scaling
is used.
If the current measured values are outside the displayable range, the range will
automatically be extended.
Note
Changing the parameter for the curve recorder in manual scaling
When the parameter for the curve recorder is changed the following occurs with manual
scaling:
•
If the current parameter has lo
wer values than the currently set scaling, the scaling will
be retained.
•
If the current parameter has higher values than the currently set scaling, the scaling
will be adjusted automatically.
Help on the curve recorder can be opened with key F1.
The curve recorder is exited by pressing the MENU button.
Note
No recording of data
The values displayed in the recorder are not recorded and saved, they are only used for
display until the screen form is exited.
6.6.5.4
AOP settings
Control settings
This defines the settings for the control keys in LOCAL mode (see "Operation / Control via
the operator panel / Operation via the operator panel").
Display settings
In this menu, you set the lighting, brightness, and contrast for the display.